Nokia Asha C2-03 Touch Screen Problem Repairing Solutions are available in the following article. This solution applies to both of these phones.
In Nokia C2-03 Touch Screen Problem can occur because of the faulty Touch Screen connector or it’s bad connection to the Cell Phone’s Motherboard. Before doing any hardware solution you should clean Nokia C2-03 Touch Screen Connector Ways and Motherboard of the Mobile Phone. If cleaning does not work then you can replace the Touch Screen connector.

I have marked all the Nokia C2-03 Touch Screen Connector Ways in the first diagram and in the second diagram I have marked the touch display IC. If the connector is in good shape don’t touch it and replace the IC marked in the second diagram.

Please Note that we will edit these solutions or add new ones if found in this page at any time in the future. So feel free to come back any time on this page to stay up to date.



If you have further Questions please don’t hesitate to leave a comment.
Note: Every diagram we post on gsmrdx.com is tested by one or more members of our team. Still Use them at Your Own Risk we are not responsible if these solutions may cause any harm to your phone.
Share this article :
Next
This is the most recent post.
Previous
Older Post

4 comments :

  1. I have a nokia c2-03 i has a problem with touch..it work good for some times but in some time the touch doesn't work...give me solution

    ReplyDelete
  2. my phone's problem is the same as jaswanth kumar. yesterday it was sorft of still working but last night until now it was totally a crap. Help please. God Bless!

    ReplyDelete
  3. i have a serious problem with my c2-03 touch screen. now i can't access the menus because the point where i touch should be has completely gone offset (about an inch up). the only thing i could do now is make/receive calls. is there any way i can access the calibration settings by using codes? cause if that so i think that would be great.

    ReplyDelete
    Replies
    1. i have a serious problem with my c2-03 touch screen. now i can't access the menus because the point where i touch should be has completely gone offset (about an inch up). the only thing i could do now is make/receive calls. is there any way i can access the calibration settings by using codes? cause if that so i think that would be great.

      Reply

      Delete

 
Top
Related Posts Plugin for WordPress, Blogger...